Choose your Automotive paint color for your 1987 Audi 200

HOME > TOUCH UP PAINT > AUDI > 1987 > CHOOSE COLOR

Restore Your 1987 Audi 200 Finish In Two Steps

Select Your Audi's Color (Step One)

AutomotiveTouchup paint products are custom mixed to perfectly match the color of your 1987 Audi 200 using a basecoat/clearcoat system just like factory specs. To insure a proper match, you’ll need to know your vehicle’s color code, so you can find it on the chart below. The paint code is normally located in the back compartment panel in the trunk. Click here for an Audi paint code location diagram and label example.

Chip Color Codes Color Description
1987 Audi 200 Touch Up Paint | Black 041, 4015, 9000, 9010, A1, A15, A1A1, L041 041, 4015, 9000, 9010, A1, A15, A1A1, L041 Black
1987 Audi 200 Touch Up Paint | Steingrau Metallic LY7U, Y7U LY7U, Y7U Steingrau Metallic

 

Don't see your color listed?


Call 1-888-710-5192
We probably have it.

Did you choose the wrong vehicle model?


Did you choose the wrong model? How about the 1987 Audi 100, 4000, 5000, 80, 90, A1, A3, A4, A5, A6, A7, A8, Coupe GT, Q7, Q8, Quattro, R8, Rs Q8, RS6, S3, S4, S5, S6, S7, S8, SQ7, SQ8, or TT?  If you're still not sure, take a look at our All 1987 Audi Models page.  Or, just go to our page dedicated to Audi Touch Up Paint

Why The Two-Step Paint System?

Your 1987 Audi 200 is painted at the factory with a high quality basecoat/clearcoat system. This two-step paint system consists of step one, the basecoat, which is your car’s actual color, and step two, the clearcoat, the specially formulated clear paint that protects the base color and provides the luster and deep shine your vehicle came with when new. AutomotiveTouchup products faithfully reproduce your vehicle manufacturer’s basecoat/clearcoat system.

Here's what our customers are saying about our Touch Up Paint:

Patrick K, owner of a 2010 Audi S5 from Denville, NJ

Nice match good work!!!

Richard B, owner of a 2008 Audi A6 from Auburn, ME

I had a chipped driver's door handle. Ordered the aerosol paint and aerosol clear coat. Prepped the area by sanding, cleaning and taped off the area and wedged up the handle to allow spray to reach the underside edges. Applied 3 coats of paint and 4 coats of clear coat. The color matched perfectly. No eggshell or running occurred. As a side note, I'm not a body man at all just an DIYer, so I was a bit nervous about the project but if you do your prep work and don't over spray than the results will be professional looking. It took about 4 hours start to finish. Very happy with automotivetouchup.com.

Share your touch up story...